Ornate Garden The Wheel Bench

This unique shaped bench offers you plenty of shade and shelter. It is ideally designed to be placed against a wall, fence or as a stand-alone picnic bench. This means that this specially shaped seat can fit into many different alcoves of space in your garden when the available space in your garden might be a crucial factor

By mounting two pressure treated laminated timber circles opposite each other we have created a cylinder. An 800mm x 1200mm table was then fixed into the centre of the cylinder with two wooden seating sections either side. This leaves you with ample room for six people to be seated within. We have assembled this cylinder Wheel Bench using our signature parts of stainless steel, polycarbonate and timber.

This unique shaped bench offers you plenty of shade and shelter. It is ideally designed to be placed against a wall, fence or as a stand alone picnic bench. This means that this specially shaped seat can fit into many different alcoves of space in your garden when the available space in your garden might be a crucial factor.

Freedom to adapt… By placing two or more wheel benchs inline and adding a roof between each unit, we can create a multitude of different sized seating areas. This would be ideal for bars, restaurants and picnic areas and would offer many different ways to use the Wheel Bench in any outdoor area.

All the parts of the Wheel Bench are manufactured from materials ideally suited to the outdoors. For extra comfort the Wheel Bench comes supplied with seat pads in a choice of 3 different colours; charcoal, green and burgundy.

• Dimensions: Height 218 x Width 220 x Depth 135cm
• Base Area: 170cm x 135cm
• Stainless steel roof to offer shade and reflect heat
• Four laminated treated sustainable spruce timber arcs
• Luxurious water resistant interior
• Seating capacity for up to six guests
• Fitted with removable table top
• A foot print of no more than a standard garden patio set.

Installation – An area of 230cm x 145cm is required for the Wheel Bench to be installed. A hard base of no less than 175cm x 140cm is preferred to build your bench onto. The Wheel Bench should be installed onto an area of flat level ground.

Ground Preparation – If you are preparing new concrete or paving area for your Wheel Bench, we recommend on an overall depth of 30cm allowing 7 days for the ground to settle prior to the arrival of our fitting team.